602-93-102-13 Fits Mercruiser MR, Alpha I & Alpha Gen II
OE# 31-36387A 1 Driveshaft Bearing
Units with driveshaft retaining nut
Not for use in units with a preload pin driveshaft
|
|
602-92-102-02 Fits Mercruiser I, R, MR, Alpha I 1973-1990 not for GEN II drives
|
|
602-92-216-04-20 Fits Mercury / Mariner 3.0 liter V6 0G960500 & up 20" model only Uses two upper driveshaft bearings
|
|
602-92-216-04-25 Fits Mercury / Mariner 3.0 liter V6 0G960500 & up 25" model only Uses two upper driveshaft bearings
|
|
602-92-216-04-30 Fits Mercury / Mariner 3.0 liter V6 0G960500 & up 30" model only Uses two upper driveshaft bearings
|
|
602-93-102-13A Fits Mercruiser I, R sterndrives
Driveshaft bearing
OE # 31-53079A-1
For use on models with pre-load pin driveshafts
Fits Mercury / Mariner
V6 (2.0 and 2.4 liter) early models
With pre-load pin driveshaft
|
|
602-92-116-04G Fits Mercruiser GEN II drives 0K999999 and below OE# 45-816919 Driveshaft for SE116 Also used on early 3.0 Mercury outboards with two piece driveshafts
|
|
|
|
602-89-101-23 Converts splined driveshaft to a hex head to aid in removing and installinf the driveshaft on Alpha one and Gen II lowers. Also works on 13 Spline Mercury 3.0L lower units.
|
|
|
|
602-92-205-04-20A Fits Mercury / Mariner metric 3 & 4 cylinder 70-125 hp 20" Two stroke Carb 13 Spline
|
|
602-92-205-04-25A Fits Mercury / Mariner metric 3 & 4 cylinder 70-125hp 25" Two stroke Carb
|
|
602-92-205-04-20B Fits Mercury / Mariner 3 & 4 cylinder 75-115hp DFI (Optimax) 20" 13 spline
|
|
602-92-205-04-25B Fits Mercury / Mariner 3 & 4 cylinder 75-115hp DFI (Optimax) 25"
|
|
602-92-205-04-20E Fits Mercury / Mariner 30-50hp four stroke Carburated 20" Bigfoot lower only 13 Spline
|
|
602-92-205-04-20G Fits Mercury / Mariner 40-60 hp 4 stroke 20" Bigfoot lower only 17 Spline
|
|
602-92-205-04-20C Fits Mercury / Mariner 4 stroke EFI 70-115hp 20" 1B366822 and below 18 Spline
|
|
602-92-205-04-25C Fits Mercury / Mariner 4 stroke EFI 70-115hp 25" 1B366822 and below
|
|
|
|
|
|