Mercury Marine Catalog - Tools & Accessories

Pulley Pusher Installer 91-93656A1

Installs the pulley on the power steering pump.

Supercedes: 91-71803A1

Remote Starter Switch 91-52024A1

Provides a remote starter button to crank the engine when performing service procedures.

Remover / Drive Pulley 91-883844

Removes the injection pump drive pulley.

Remover / Injector Sleeve 91-883856

Removes the injector sleeve.

Retention Sleeve Removal Tool 91-862546

Removes the aluminum sleeve from the U-joint bellows of all the Bravo and Blackhawk drive units, Serial Number 0L999999 and below.

Reverse Gear Needle Bearing Driver 91-816244

Installs the needle bearings into the reverse gear of the Alpha One and Alpha One Gen II counter rotating gear case.

Rocker Stopper 91-66273 (Priced Each. Must be sold in quantities of 4)

Plugs the oil holes in the rocker arms to eliminate oil spray while adjusting the valve lash.

Roller Bearing Removal and Installation Tool 91-37292

Part of 91-31229A7 Bearing Removal and Installation Tool Assembly, use with the threaded puller rod or driver rod.

SAE Dial Indicator Adaptor 91-816997A1

Use with the SAE dial indicator to set the fuel injector pump timing.

Supercedes: 91-854220

Seal / Bearing Driver 91-63619T

Installs the drive shaft bearing cup and U-joint oil seal in the drive shaft housing of the TR and TRS drive units. Also, installs the TR drive unit propeller shaft bearing cup.

Supercedes: 91-63619

Seal and Bushing Installation Tool 91-806928A1

Installs the shift shaft bushings in the Alpha One Gen II drives with serial number 0F094775 and Above.

Seal Driver 91-43591T

Installs the upper drive shaft oil seal on the Alpha One and Alpha One Gen II drive units.

Supercedes: 91-43591

Seal Driver 91-44110T

Installs the oil seals in the water pump base on the Alpha One and Alpha One Gen II drive units.

Supercedes: 91-44110

Seal Driver 91-813653T

Installs the U-joint oil seal into the bearing carrier. Also use to pilot the puller rod for the gear housing needle bearing installation on all the Bravo drive units.

Supersedes: 91-813653, 91-89868

Supercedes: 91-89868, 91-813653

Seal Driver 91-864497

Installs double lip seal in driveshaft housing.

Seal Driver, Bearing Carrier Seal 91-805372

Installs the seals in the Blackhawk and Bravo Three drive unit bearing carriers.

Seal Driver, Outer Propeller Shaft 91-805358T

Installs the seals in outer propeller shaft of the Bravo Three and Blackhawk drive units.

Supercedes: 91-805358

Seal Removal Tool 91-862064A1

Use to remove the needle bearing and oil seals in the bearing carrier of all the Bravo Three drive units.
25-805048 Replacement O-Ring

Shift Cable Adjustment Tool 91-12427T

Attaches over the shift cable. Use for proper Bravo drive unit shift cable adjustment at the shift plate.

Supercedes: 91-12427

Shift Cable Anchor Adjustment Tool 91-17262A1

Use to install and remove shift shaft bushings on all Bravo drive units.
91-17262A1 Core Wire Locating Tool
91-17263 Shift Cable Anchor Adjustment Tool