Serial 0B721206 Thru 0D805068 - Bravo Drives

Slide Hammer Puller 91-34569A1

Removes the bearings and bearing cups.
91-34570 Replacement jaw.

Supercedes: 91-31228A1, 91-31228A2, 91-31228A3, 91-31228A3

Spanner Wrench 91-821709T

Removes the trim cylinder end cap on all Mercury MerCruiser and Mariner trim cylinders. Uses interchangeable pin sets:
91-811907 Large pin set 0.235 in. (5.97 mm)
91-811908 Medium pin set 0.180 in. (4.57 mm)
91-811909 Small pin set 0.150 in. (3.81 mm)

Supercedes: 91-821709

Spanner Wrench For L-18 U-joint Bearing Retainer 91-862219A1

Removes and installs the drive shaft bearing retainer on the Bravo XZ, XR and Diesel Bravo drive units.
91-862218 Replacement pins (5)

Supercedes: 91-862219

Spline Backlash Tool 91-806192

Measures the Bravo Three and Blackhawk propshaft-to-gear spline backlash while on V-blocks.

Steel Bearing Adaptor Socket 91-862531

Removes and installs the steel bearing adaptor on the Bravo X Series drive units.

Stub Shaft for Bravo X Series 91-865083

Replaces the U‑joint assembly during the shimming process of the driveshaft housing.

Stub Shaft for Standard Bravo 91-865084

Replaces the U‑joint assembly during the shimming process of the driveshaft housing.

Tapered Insert Tool 91-43579

Installs the tapered insert retainer into the water inlet hose on all the Bravo and Blackhawk drive units.

Torque Wrench, lb-in. 91-66274

Sets torques from 9 to 150 lb-in; 3/8 in. drive.

Transom Cutout and Drill Fixture 91-43693A2

Use for cutting and drilling the boat transom for sterndrive installation.

Supercedes: 91-71024A2

Trim Pump Test Gauge Kit 91-52915A6

Use in various trim pump tests.

Supercedes: 91-52915A8, 91-52915A3

U-joint Adaptor 91-38756

Supports the yoke when disassembling U-joint on all the drive units.

Universal Puller Plate 91-37241

Removes gears and bearings.

Supersedes: 91-32337A1, 91-35427A1

Vertical Shaft Service Tool 91-805474

Use with the various drivers to install the Bravo and Blackhawk drive unit bearings.

Washer 12-34961

Use on the threaded puller rod between the nut and plate when removing bearings.